How it connects
Unstripped wires are inserted fully into the parallel entry holes; pressing the cap down with pliers drives a U-shaped metal blade through the insulation into both conductors. Silicone gel inside seals out moisture.
Male and female halves
Not a gendered mating pair; the splice body is a receptacle (wire entry) that accepts bare-ended, unstripped wires. 'Female' here just means the holes that receive the wire.
Usually connects to
- unstripped solid copper wire 19-26 AWG (telephone, alarm, thermostat, low-voltage cable)
Common sizes
- Typically 19-26 AWG solid copper (some listings 22-26 AWG), insulation OD up to about 2 mm; 2-wire (UY/UY2) is most common, with 3-wire (UR) and tap (UG) relatives.
Where it is used
telephone wiringsecurity/alarm wiringlow-voltage and data cablingthermostat and irrigation control wire
Variations
- UY / UY2 2-wire butt splice (yellow cap)
- UR 3-wire butt splice (red cap)
- UG tap splice
- UB2A
- K1/K2 butt splices
How to recognise it
Small (~10 mm) clear plastic body with a translucent yellow/orange push-down cap; two parallel round holes on one side, gel visible inside, metal IDC blade visible through the cap.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| UR connector | UR has a red cap and three wire entries; UY has a yellow cap and two. |
| Twist-on wire nut | Wire nuts need stripped wire and are twisted on; UY has no thread and is crimped shut on unstripped wire. |
| Butt splice crimp terminal | Standard butt splices have wires entering from opposite ends; UY entries are side by side on the same end. |
Also called
UY2 connector3M Scotchlok UYbeanie / B-connector (loosely)gel-filled IDC butt splicejelly crimpPresslok spliceK1 / K2 connector (similar)
Good to know
UY is a 3M part designation that has become generic; Klein, Ideal and others sell clones. Not a separable connection — it is a permanent splice.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

