How it connects
Two flat parallel blades push straight into receptacle slots and are held by spring contacts (friction). The wider neutral blade only fits the wider (neutral) slot, fixing polarity. No seal, no latch.
Male and female halves
P = plug (male, blades); R = receptacle (female, slots). This is the male plug. It also mates with grounded 5-15R/5-20R outlets, the ground hole left unused.
Usually connects to
- NEMA 1-15R receptacle or extension-cord outlet with compatible polarization
- NEMA 5-15R receptacle, using line and neutral slots only
- NEMA 5-20R T-slot receptacle
Common sizes
- One 15 A, 125 V configuration: blades about 6.3–6.35 mm wide × 1.5 mm thick, on 12.7 mm (1/2 in) centres, about 15.9–18 mm long.
- Polarized plugs have a wider neutral blade, about 7.9 mm (5/16 in), versus the approximately 1/4 in hot blade. Check NEMA WD 6 for exact tolerances.
Where it is used
consumer electronicssmall household appliances; small motors and fanslampstimerswall-plug transformers and power adapters; chargers and power adapterspower cords (e.g. to IEC C7)extension cordsoutdoor electric accessories
Variations
- Polarized wide neutral or non-polarized equal blades
- Straight, right-angle, flat/low-profile body
- Blades with/without holes
- JIS C 8303 Class II Japanese equal-blade version with different tolerances
- Integral wall-transformer blades
How to recognise it
Two flat parallel blades and no ground pin, with one blade (neutral, often marked W or ribbed cord side) noticeably wider than the other. Blades often have holes near the tip. Found on cords, wall-wart and timer plug faces.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| NEMA 5-15P | 5-15P has a third round or U-shaped ground pin; 1-15P has only two blades. 5-15P has a third round/U-shaped ground pin below the blades; 1-15P has only two blades. |
| Non-polarized NEMA 1-15P / JIS C 8303 Japanese plug | Both blades are the same narrow width; the polarized one has one visibly wider blade. |
| NEMA 1-15R | R is the female receptacle with slots; P has protruding blades. |
| Euro CEE 7/16 (Type C) | Type C has two round pins; Type A has flat blades. |
| Chinese/Australian flat-pin plugs (Type I) | Type I blades are angled in a V; Type A blades are parallel. |
Also called
NEMA 1-15PPolarized two-prong/two-blade US plugTwo-prong/two-pin US plugJIS C 8303 Class II plug (Japan)
Good to know
A pass-through timer can have a 1-15P plug and 1-15R outlet. This is an ungrounded two-blade connection, with a wider neutral on polarized versions, rather than 5-15.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.



