How it connects
Two grooved resin clamp plates sandwich the adjoining wire rails of the corner and straight shelf decks, secured together by a central machine screw and nut to form a rigid butt joint.
Male and female halves
Neutral clamp interface consisting of two symmetric mating clamp halves (or a front/back clamp pair) tightened across abutting wire rails.
Usually connects to
- ClosetMaid 12-inch Shelf & Rod wire shelving deck rails
- wire shelving support lip / front rod
Common sizes
- Designed for standard ClosetMaid wire shelving wires (approx. 4 mm to 6 mm wire gauge with standard rail center-spacing on 12-inch deep Shelf & Rod decks).
Where it is used
residential closet storagewire closet shelving installationmodular shelving systems
Variations
- ClosetMaid 1002 Universal Joiner Plate
- ClosetMaid 100200 Joiner Plate Set
- ClosetMaid corner support bracket (stamped steel strap)
How to recognise it
Recognizable as a compact white resin rectangular clamping block with pre-formed semicircular wire channel grooves along the edges and a central machine screw tightening the two plates together around adjacent shelf wires.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| ClosetMaid 1001 Corner Support Bracket | The 1001 bracket is a single stamped steel offset strap supporting the front hang rod rather than a two-piece clamped block joining deck wire rails. |
| Kee Klamp / slip-on pipe clamp fittings | Kee Klamps are heavy structural pipe fittings with set screws for tubular pipe, not small plastic wire-mesh clamps. |
Also called
ClosetMaid Universal Joiner Platewire shelf joiner clampshelf-to-shelf corner connector clamp
Good to know
Used specifically on ClosetMaid wire shelving systems (such as the 21066 12 in. Corner Shelf kit) where straight wire shelving meets a corner unit at 90 degrees.
Design with real parts
Crafti checks which parts connect, right in your browser.