Chain Grab-Hook Throat

How it connects

Insert a selected chain link through the open mouth and seat it in the narrow throat. The hook geometry holds the chain at that link under load; this is a mechanical engagement with no fluid seal.

Male and female halves

Hook and chain link are the usual mating terms, rather than male and female. “Female” here describes the receiving throat informally; it does not identify a standardized female socket.

Usually connects to

• Welded chain link matched to the hook manufacturer’s specified size and grade

Common sizes

• The sample is nominally for 1/4-inch (6.35 mm) chain stock. This is the chain material diameter, not the throat width. Other grab hooks are sized for other chain diameters; use the stated chain size and grade rather than estimated photo dimensions.

Where it is used

Chain tie-downsChain length adjustmentcargo chain securementalloy chain sling shortening with appropriately rated hardware

Variations

• Clevis grab hook: pin attachment at the opposite end
• Eye grab hook: closed eye attachment at the opposite end
• Non-cradle grab hook
• Chain-shortening grab hook
• Eye attachment or clevis attachment at the opposite end

How to recognise it

Look for an open hook with a narrow slot leading to a curved chain seat. Check stamped chain size and grade and the manufacturer’s chain compatibility data. A clevis pin or eye at the back identifies the hook’s other attachment, not the throat interface.

Often confused with

Also called

chain grab hook throatgrab hook openingchain-engaging throatgrab hook chain-engaging slot

Good to know

A grab-hook throat is a mating feature rather than a universal connector designation. Wide-throat slip hooks and different hook grades do not establish interchangeability.

From the Crafti Connection Guide: researched from manufacturer documentation and standards, organised by the Crafti team. Use it as a guide and check the manufacturer's specifications. How this guide is made · Report a correction