How it connects
The pin's smooth cylindrical shank slides into the hole by hand and is held by a slip-to-light friction fit. The shelf's weight presses it into place. There is no seal or lock. Some pins have a threaded or barbed shank for a tighter hold.
Male and female halves
This is the female half: the hole in the panel. The male half is the shelf pin's shank.
Usually connects to
- Matching shelf pin/peg, commonly 5 mm or 1/4 in, in plain, spoon, angled/L-bracket, plastic-sleeved or locking forms
- Matching metal/plastic pin sleeve or bushing insert
Common sizes
- Common pins: 5 mm for European/System 32 cabinets, 1/4 in (6.35 mm) for North American furniture and 3 mm for small/glass shelves.
- Hole depths roughly 6–13 mm, often 8–12 mm. System 32 holes repeat at 32 mm vertical pitch, commonly about 37 mm from the panel edge.
Where it is used
bookcaseswardrobes and closetsflat-pack / RTA furnitureframeless/European cabinetrycase furniturekitchen and bath cabinetscloset systems
Variations
- 5 mm System 32 bore
- 1/4 in bore
- Other 3 or 7–8 mm bores
- Pressed-in metal/plastic sleeve or grommet
- Locking shelf support
How to recognise it
A vertical row (often two rows, front and back) of small round blind holes about 5 mm across, evenly spaced (often 32 mm), on the inside faces of cabinet sides. The holes are smooth with no thread.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Dowel hole / cam-lock bolt hole | Dowel holes (often 8 mm) are glued and permanent, and usually sit at panel edges or joints. Shelf pin holes are 5 mm, come in evenly spaced rows on the inner face, and are left empty until a pin is pushed in. |
| Hinge cup bore (35 mm) | The hinge cup bore is much larger and sits on doors, not on carcass sides. |
| Hinge/cam/dowel holes of the 32 mm system | Hinge cup holes are 35 mm; cam holes ~15 mm; dowel holes 8 mm. Shelf pin holes are small (5 mm) in long evenly spaced vertical rows near the front and back edges. |
| Screw pilot holes / threaded inserts | Pilot holes are isolated and hold screws; shelf pin holes come in rows and accept unthreaded pins. |
| Dowel hole (dowel joint) | Dowel holes are usually 8 mm, in pairs at panel edges/faces for permanent glued joints; shelf pin holes are 5 mm in long vertical rows. |
Also called
Shelf pin/peg support holeAdjustable shelf holeSystem 32 line-bore/system holeCabinet shelf-support bore
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


