How it connects
Vertical linear sliding insertion of the cylindrical rod tip into a ground-embedded receptacle, pipe sleeve, or bore hole. Held in engaged or disengaged position via gravity, retention tabs, or hook brackets.
Male and female halves
Male cylindrical rod (this interface) mating by sliding down into a female tubular sleeve, socket, or ground-level strike hole.
Usually connects to
- Matching keeper/strike/staple or drop-rod receptacle
- Matching ground/floor socket, receiver pipe or drilled pavement/concrete/soil hole
- Matching guide bracket/collar
Common sizes
- Small slide bolts are named by body length, about 1-1/2–12 in (40–300 mm), with rods roughly 5–16 mm.
- Gate/drop rods commonly 3/8–3/4 in (10–20 mm), especially 1/2, 5/8 and 3/4 in, with lengths 12–48 in (300–1200 mm).
- Typical throw/engagement about 2–6 in (50–150 mm).
Where it is used
fences and gates; agricultural fencing; agricultural gatesdouble swing driveway gatespedestrian garden gatescommercial security gatesdoorsshedscabinetsfurniture hardware
Variations
- bent cane handle rod; straight drop rod with handle pin
- padlockable / key-lockable drop bolt; internal / profile-mounted drop bolt
- surface weld-on or screw-on bracket drop rod
- straight barrel bolt; spring-loaded barrel bolt
- offset/cranked keeper
- tower bolt (UK)
- heavy-duty gate bolt
- L-handle cane bolt; J-hook cane bolt
How to recognise it
Recognizable as a sturdy vertical cylindrical metal rod (often bent at the top like a cane handle or fitted with an operating knob) attached to the lower rail of a gate leaf via guide brackets, with the straight bottom tip protruding downward.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| surface slide barrel bolt | Barrel bolts typically mount horizontally across leaves or jambs with smaller throws, whereas cane bolts/drop rods are long vertical rods dropped downward into the ground or pavement. Barrel bolts typically slide horizontally to bridge a door gap, whereas cane bolts are long vertical drop rods that slide down into the ground or sill. |
| ground socket / receiver (female) | The female half is an embedded tubular receiver or ground plate flush with the terrain, whereas this is the male sliding cylindrical rod mounted to the gate leaf. |
| flush bolt | A flush bolt is set into a mortise in the door edge or face; a barrel bolt is surface-mounted with the rod in an exposed barrel. |
| spring latch / tubular latch | Those have a beveled spring-loaded latch tongue retracted by a handle; a barrel bolt is a plain round rod slid by hand. |
| Cremone bolt | Cremone bolts use a central rotating knob or lever with internal gearing that simultaneously drives upper and lower vertical rods. |
Also called
drop boltgate drop pin; drop rod pinground latch rodgate ground stop boltslide bolt; slide latchtower bolt; surface boltbarrel bolt latchcane bolt tip
Good to know
Commonly used on double-leaf gate systems where one leaf is anchored to the ground using the drop rod while the active leaf latches against it.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


