How it connects
Pegboard accessory prongs or tabs are inserted into the unthreaded circular holes and held in place by cantilever gravity, friction, or secondary locking screws/clips.
Male and female halves
Female perforated hole receiving male pegboard prongs, hooks, or mounting pins.
Usually connects to
- Matching pegboard hook/prong, peg, tool-holder or accessory mount
- Matching bracket pin/tab
- Compatible pegboard locking screw
Common sizes
- Common pegboard holes: 1/8 in (3.18 mm), 3/16 in (4.76 mm) or nominal 1/4 in (6.35 mm, with some holes about 9/32 in/7.14 mm).
- Typical square grid 1 in (25.4 mm); some 1/8 in boards use 1/2 in pitch. Panels commonly 1/8–1/4 in thick.
Where it is used
Workshop tool organizationGarage wall storageRetail display fixturesCraft rooms
Variations
- 1/4 in heavy round hole on 1 in centres
- 3/16 in medium or 1/8 in light hole
- Metric 5/6 mm hole on 25 mm centres
- Slotted pegboard
- Metal-panel version
How to recognise it
Recognized as a regular matrix or grid of unthreaded circular through-holes spaced evenly (usually 1 inch on-center) across a flat panel of hardboard, metal, or plastic.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| slotted pegboard hole | Slotted pegboards feature vertical or horizontal oblong slots rather than circular round holes. |
| cleat wall slot | French cleats and slatwalls use horizontal grooved rails or channels instead of an array of individual round holes. |
| Metric Pegboard (25 mm pitch) | Imperial pegboard uses 25.4 mm (1.00 in) hole spacing, whereas metric pegboard uses 25.0 mm spacing; multi-hole accessories will bind if cross-installed over multiple holes. |
| IKEA SKÅDIS | IKEA SKÅDIS uses vertical oblong pill-shaped slots rather than round holes. |
| Wall Control / Slotted Pegboard | Wall Control panels feature vertical rectangular slots alongside round holes. |
Also called
Pegboard/perforated-panel holePerforated hardboard socketPeg-hook receiver1/4 in pegboard hole on 1 in grid
Good to know
Often used in pairs or groups by single hooks and accessory brackets. Some systems (like Triton DuraHook) utilize adjacent upper and lower holes for stabilizing tabs and locking screws.
Design with real parts
Crafti checks which parts connect, right in your browser.
