How it connects
Telescoping gravity-lap slip joint where the crimped/reduced male end inserts downward into the female section; typically secured with sheet metal screws or pop rivets and sealed with gutter sealant.
Male and female halves
Male half is the tapered or fluted/crimped end with reduced outside dimensions. It slips inside the full-dimension uncrimped female receiver socket.
Usually connects to
- Matching rectangular downspout female/uncrimped receiving section or elbow inlet
- Matching rectangular joiner/connector sleeve
Common sizes
- Common nominal sizes: 2 × 3 and 3 × 4 in residential, 4 × 5 in commercial (about 51 × 76, 76 × 102 and 102 × 127 mm).
- Some profile descriptions give 2-1/4 × 3-1/4 or 3-1/4 × 4-1/4 in; confirm actual profile and slip clearance.
Where it is used
Residential/commercial gutter/roof runoff drainageArchitectural sheet-metal downspoutsRainwater collection/harvesting
Variations
- Factory-fluted/roll-crimped aluminum or galvanized end
- Field crimp using 3-/5-blade tongs
- Molded vinyl spigot
- Smooth or corrugated rectangular profile
- Smooth tapered reduction
How to recognise it
Recognised by a rectangular cross-section with longitudinal corrugations or fluted crimps narrowing the perimeter at one end by roughly 1/8 inch over a 1 to 2 inch length, allowing it to slide into another downspout or elbow.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Rectangular HVAC duct slip-and-drive connection | HVAC duct ends use S-cleats and drive clips without corrugation or downward gravity lap, whereas downspouts use fluted/crimped tapered ends lapped inside the lower section. |
| Round downspout crimp | Round downspouts have cylindrical circular cross-sections, while this interface has a 2x3 or 3x4 inch corrugated rectangular profile. |
| Round downspout crimped end | Round downspouts have a circular cross-section, whereas rectangular downspouts have a 2x3, 3x4, or 4x5 inch rectangular cross-section. |
| Round sheet metal pipe crimp | Rectangular downspout crimps are formed on flat-sided rectangular profiles rather than cylindrical duct or pipe. |
| Downspout bell socket (female) | The female end is expanded or left at full nominal profile; the crimped spigot is pleated and reduced in outer dimension to insert inside. |
Also called
male downspout slip enddownspout drop endcrimped gutter elbow endcrimped downspout spigotmale downspout slip joint; Crimped male downspout slipcrimped downspout elbow endCrimped leader pipe enddownspout male spigot
Good to know
Always oriented pointing downward in the direction of water flow so that runoff flows past the lap joint rather than leaking out.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


