How it connects
The smooth tube end slides into the receiving female slip-joint hub or trap adapter, where a beveled slip-joint washer is compressed around the tube's outer diameter by a threaded slip-joint nut to form a watertight seal.
Male and female halves
Male plain-end spigot (smooth OD tube) that inserts into a female slip-joint socket equipped with an external thread, compression washer, and nut.
Usually connects to
- Matching female tubular slip socket, P-trap socket or extension coupling
- Matching trap adapter (Marvel/desanco/desanko)
- Matching tubular nut and beveled washer, including 1-1/2 in examples
Common sizes
- US tubular ODs commonly 1-1/4 in for lavatories and 1-1/2 in (1.500 in, 38.1 mm) for kitchen/tub drains.
- Reducing washers adapt 1-1/2 in joints to 1-1/4 in tubes. EU/UK counterparts are around 32/40 mm.
Where it is used
Residential/commercial tubular DWVSink/lavatory waste linesP-trap and fixture-tailpiece assemblies
Variations
- Rough/chrome-plated brass in 17/20/22 gauge
- PP/PVC tube
- Straight extension or wall-bend/waste arm
- 1-1/4 in OD version
How to recognise it
Smooth, unthreaded cylindrical tube end with thin walls (brass or polypropylene) measuring exactly 1-1/4" or 1-1/2" OD, lacking external threads or flanges, intended to be inserted into a slip-joint nut and washer.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| nominal DWV pipe spigot (Schedule 40 PVC/ABS/copper) | Tubular drainage is measured strictly by true outside diameter (1.25" or 1.5" OD) with thin walls, whereas Schedule 40 DWV pipe uses nominal pipe size (1.5" nominal pipe has a 1.90" OD) and thick walls. |
| direct connect tubular flanged tailpiece | Direct connect tailpieces have an integral flared lip or flange at the end that captures a captive nut, whereas this interface is a continuous plain smooth tube end without a flange. |
| 1-1/2 inch Schedule 40 DWV pipe spigot | Tubular drain pipe has an exact 1.50 in (38.1 mm) OD with thin walls, whereas Schedule 40 PVC/ABS pipe has a 1.900 in (48.3 mm) OD and much thicker walls. |
| Tubular flanged tailpiece end | A plain spigot is straight and cylindrical without a flared lip or flange at the end. |
| 1-1/2 in Schedule 40 PVC / DWV pipe spigot | Tubular drainage has an exact outer diameter of 1-1/2 in (38.1 mm) with thin walls, whereas Schedule 40 1-1/2 in pipe has a nominal size with an actual OD of 1.900 in (48.3 mm). |
Also called
tubular drain spigotslip joint male spigottubular waste arm outlet1-1/2 tubular drain plain end; 1-1/2 inch tubular tailpiece plain end1-1/2 tubular slip spigot; 1-1/2 OD tubular brass/plastic spigot1-1/2 inch tubular tailpiece / wall bend outletExtension tube plain endslip-joint tube end
Good to know
Often encountered on P-trap wall arms (waste bends) and tubular extension tubes where the outlet tube slips into a wall-mounted trap adapter (often called a Desanko fitting) that supplies the nut and sealing washer.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


