How it connects
The downward molded rear lip slides over an upward-turned wall bracket or cleat, holding the fixture against the wall under gravity, often secured with secondary underside screws or adhesive.
Male and female halves
Female interface (the downward recess or lip channel on the fixture) which receives the male interface (the upward-protruding wall bracket or hanger rail).
Usually connects to
- wall mounting bracket
- sink hanger bracket
- mounting cleat
- support bar
Common sizes
- Typically spans 8 to 24 inches (200 mm to 600 mm) wide, with a lip recess depth of 0.25 to 0.75 inches (6 mm to 20 mm).
Where it is used
residential plumbingcommercial plumbinglaundry and utility roomssanitary fixture installation
Variations
- continuous rear cleat lip
- dual-slot / pocket hanger tabs
- reinforced thermoplastic mounting channel
How to recognise it
Recognized on the rear exterior upper perimeter of a wall-mount sink as a downward-turned hollow rim, overhang channel, or recessed pocket specifically shaped to slot over an upward-facing metal mounting bracket.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| French cleat | A French cleat relies on complementary 45-degree beveled strips, whereas sink hanging lips are typically 90-degree downward hooks or vertical stamped sheet metal/molded channels. |
| Drop-in sink rim | A drop-in sink rim rests horizontally on a countertop opening rather than interlocking vertically over a wall-mounted bracket. |
Also called
sink mounting rimsink hanger liprear mounting channelwall hanger pocketsink mounting flange
Good to know
Commonly found on thermoplastic, cast iron, and vitreous china wall-hung lavatories and utility basins. While proprietary in exact dimensions across manufacturers (such as Tehila, Kohler, American Standard), it functions universally as a gravity-drop bracket/cleat hanger.
Design with real parts
Crafti checks which parts connect, right in your browser.
