How it connects
Direct connection via a threaded coupling nut compressing a flat washer against a flanged tailpiece, or slip-joint mating using a threaded slip nut and beveled friction washer around an unthreaded 1-1/2" OD tubular pipe.
Male and female halves
Male straight threads on the bottom exterior of the drain body/strainer (1-1/2" NPSM) mating with a female slip/coupling nut holding a flanged or plain-end tubular tailpiece.
Usually connects to
- 1-1/2" flanged sink tailpiece
- 1-1/2" threaded sink tailpiece
- 1-1/2" slip joint P-trap inlet
Common sizes
- 1-1/2 inch nominal OD tubular pipe (actual OD 1.50 in / 38.1 mm; threads typically 1-1/2"-11.5 NPSM).
Where it is used
residential plumbingcommercial kitchen plumbingutility sinks
Variations
- Flanged tailpiece connection (direct connect)
- Threaded tailpiece connection
- Slip-joint connection
How to recognise it
Recognised by a straight, unthreaded or male-threaded cylindrical outlet directly below the sink strainer cup, measuring 1-1/2 inches (approx. 38 mm) outer diameter, designed to accept a slip nut or coupling washer.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| 1-1/4 in Sink Drain Tailpiece | 1-1/4 inch is standard for bathroom lavatory drains (1.25 in OD), whereas 1-1/2 inch (1.50 in OD) is standard for kitchen and utility sink drains. |
| 1-1/2 in NPT Pipe Thread | Tailpiece threads are straight tubular mechanical/fixture threads (NPSM) sealed by a compression gasket or slip washer, whereas NPT threads are tapered and seal on the thread interference. |
Also called
1-1/2" tubular drain connectionsink tailpiece connection1-1/2" slip joint drain connection
Good to know
Sink strainers and utility drains typically feature external straight threads (1-1/2-11.5 NPSM) that allow either direct attachment of a flanged tailpiece with a coupling nut or a slip-joint adapter.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.



