How it connects
Toilet is lowered so the horn squashes into a wax ring seated on the closet flange; the deformed wax seals horn to flange. Two closet bolts through the flange and toilet base clamp it down. No threads or glue.
Male and female halves
The horn is the male/spigot half; the closet flange plus wax ring is the female/receiving half. This connection is the male (toilet) side.
Usually connects to
- Compatible wax ring, plain or with plastic horn sleeve
- Compatible wax-free foam/rubber toilet seal
- Closet flange on 3 or 4 in DWV drain, with T-bolts holding the floor-mounted bowl
Common sizes
- Fits 3 and 4 in (DN75/DN100) closet-flange drain systems, commonly 3 × 4 in. Ceramic horn bores around 2–2-3/8 in (50–60 mm); horn OD roughly 2.5–3.5 in, with flange contact surfaces around 3–4 in.
- Bolt slots lie around a 6 in circle; toilet rough-ins are 10/12/14 in from wall to flange centre, most commonly 12 in.
- Standard and extra-thick/jumbo wax seals accommodate the assembly; actual horn dimensions vary.
Where it is used
Residential/commercial floor-mounted toiletsBathroom sanitary drainageToilet installation
Variations
- Regular plain wax ring
- Extra-thick or reinforced ring for recessed flange
- Plastic horn/sleeve/funnel ring
- Compatible rubber/silicone/foam wax-free seal
- PVC/ABS, cast-iron or stainless flange
- Offset flange
How to recognise it
Turn the toilet on its side: a round, slightly tapered ceramic spigot in the centre of the base footprint, surrounded by a flat ring area where the wax sits, with two bolt slots either side of it at the base. Often has old wax residue.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| PVC/ABS pipe spigot | A pipe spigot is a uniform plastic tube that is solvent-welded or gasketed into a hub; the toilet horn is a short ceramic protrusion on the bowl underside sealed only by a wax ring. |
| Rear-outlet (wall-hung / P-trap) toilet connection | Rear-outlet toilets discharge horizontally through the wall via a gasket/carrier; the closet horn points down into the floor. Rear-outlet toilets discharge horizontally into the wall via a rubber pan connector, not down into a floor flange with wax. |
| Plastic wax ring horn/funnel | The plastic horn is a directional sleeve built into some wax gaskets, whereas the closet outlet horn is the ceramic male spigot molded directly into the toilet bowl base. |
| Wall-hung closet rear spigot outlet | Wall-hung bowls discharge horizontally through a neoprene or rubber gasket into a carrier fitting, rather than downward onto a floor wax ring. |
| Closet flange | The flange is the rigid floor fitting with bolt slots; the wax ring is a soft, disposable gasket sitting on it. |
Also called
Toilet discharge/outlet horn or spigotWater-closet bowl outletFloor-mount toilet-to-flange connectionWax-ring/gasket seal, including horn-sleeved types
Good to know
Toilet horn dimensions vary; the wax ring accommodates that variation. An estimated 85 mm outside diameter is not a universal horn size.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

