How it connects
The rope legs sit side by side between the U-bolt and the saddle. Tightening the two nuts to the specified torque clamps them together by friction. Several clips are spaced along the turnback. There is no seal.
Male and female halves
Genderless. The clip receives two rope legs: the saddle bears on the live (loaded) leg and the U-bolt on the dead (tail) leg ('never saddle a dead horse').
Usually connects to
- Two parallel runs of matching-size wire rope, commonly the live/dead ends of doubled-back cable
- Thimble in a looped eye
- Compatible shackle, turnbuckle, anchor eye, eyebolt or clevis pin in the termination assembly
Common sizes
- Sized by rope diameter: broad ranges span 1/16–3-1/2 in (about 1.5–90 mm), with common light sizes 1/8, 3/16, 1/4, 5/16, 3/8 and 1/2 in; metric descriptions include M3–M40+.
- Crosby G-450 covers 1/8–3-1/2 in as one manufacturer range. A nominal 1/8 in rope is 3.175 mm; this does not define every clip’s range.
Where it is used
Application-appropriate rigging/lifting/cranesWire-rope eye terminationsFences, guy wires and mast supportsCable railingsMarineLight-duty agricultural/general hardware
Variations
- Drop-forged heavy-duty saddle
- Malleable cast-iron light-duty clip, not for overhead lifting
- Stainless clip
- DIN 741 clip
- Double-saddle/fist-grip counterpart, without a U-bolt
How to recognise it
A U-shaped threaded rod passes through a grooved, often ridged saddle and is held by two hex nuts. Two parallel cables run through it, often next to a thimble eye.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Double-saddle / fist-grip wire-rope clip | It has two saddles and a J-bolt, so it can go on either way round. A U-bolt clip has only one saddle. Uses two saddles rather than one saddle opposed by a U-shaped bolt. A fist grip has two saddles and J-bolts, no U-bolt, and can go on either way round. |
| Duplex / swaged cable sleeve (ferrule) | A sleeve is a crimped metal tube or figure-8 with no bolts or nuts. |
| Plain U-bolt pipe clamp | A pipe U-bolt holds one pipe against a flat plate or strap. A rope clip's saddle has grooves for two rope legs. |
| Duplex / double-barrel cable clamp | That one is a flat plate with two parallel holes and screws, with no U-bolt. |
Also called
U-bolt wire-rope clip/clamp/gripCrosby clipBulldog grip/clipSaddle clipCable-loop/eye termination with clips
Good to know
The clip has two parallel rope-receiving channels sharing one grip. Strength figures depend on correctly installed forged clips, often at least 2–3 clips depending on size.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

