How it connects
The transverse wire of the wire shelf is pressed down into the upward-facing hook slots on the top flange of the bracket, capturing the wire and preventing forward, backward, or lateral slippage.
Male and female halves
Female receiver (the stamped hook slots/notches on the bracket accept the male transverse wire rod of the shelf)
Usually connects to
- Matching ventilated shelf deck/frame wire, transverse or longitudinal, including regular/heavy-duty ClosetMaid wires and truss rods
- Compatible sidewall support bracket
Common sizes
- Wire diameters commonly 3–6 mm (1/8–1/4 in), often 4–5 mm coated wire.
- Notches typically 6–12 mm wide × 5–10 mm deep; bracket/shelf depths include 10, 12, 14, 16 and 20 in. Match wire position as well as diameter.
Where it is used
Residential/retail adjustable wire shelvingCloset organizationGarage, pantry and utility storage
Variations
- Gravity-saddle notch, locking snap/tab or non-locking hook
- Hang-rod-compatible bracket
- ShelfTrack, compatible FastTrack or Elfa cradle profile
- Heavy-duty dual-slot cantilever notch
- Fixed-mount angled/diagonal support tip
How to recognise it
Pair of upward curved or notch-like hook profiles stamped directly into the top edge/flange of a steel ShelfTrack shelf bracket, designed to cradle a single cross wire of the shelf.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| ShelfTrack standard slot connection | The upright slots mate with the rear downward hooks of the bracket onto the wall standard, whereas these retaining hooks are along the top edge of the cantilever bracket to hold the wire shelf itself. The standard slot connection is the rear lug/hook that mates vertically into slotted wall standards, whereas this interface is along the top edge of the cantilever arm that supports the wire shelf. |
| Fixed-mount wire shelf wall clip | Wall clips mount directly to drywall with anchors rather than being integral stamped features on an adjustable cantilever bracket. Wall clips mount directly to drywall/studs at the back wall rather than acting as a cantilever bracket arm support. |
| Twin-track / double-slotted wall standard hook | The wall standard hook is at the rear vertical upright that inserts into the wall track, whereas this interface is along the top horizontal edge supporting the wire deck. |
| Wall-mounted back-wall shelf clip | Back-wall clips anchor directly to drywall or studs to hold the rear wire, whereas this interface is integrated into cantilevered track brackets. |
Also called
ShelfTrack wire shelf bracket retaining slots; ShelfTrack shelf bracket wire retention notch; wire shelf bracket cradle notchClosetMaid bracket locking hooksshelf retaining tabswire shelf bracket saddleWire shelving support bracket interface; wire shelving support notchwire shelf locking notchWire shelf bracket top hook; wire shelf support bracket top channelwire retaining notch
Good to know
Described as female because the bracket features the socket/slot receiver while the shelf wire acts as the male mating member.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

