How it connects
Conduit is pushed into the open sleeve until it bottoms; a single machine screw through the saddle ears squeezes the strap onto the armor's outer surface. Mechanical grip and grounding continuity only; not watertight (dry locations).
Male and female halves
Female (receptacle) side: the conduit is inserted into it. The mating FMC is the male/inserted member. The other end of the fitting is typically a male locknut thread for a knockout, an EMT set-screw end, or another flex end.
Usually connects to
- Matching trade-size FMC/Greenfield, including reduced-wall types where rated
- AC/BX armored cable
- MC cable where listed
- NM cable on approved combination/duplex fittings
Common sizes
- Trade sizes 3/8–4 in; 3/8, 1/2, 3/4 and 1 in are common residential choices.
- 3/8 in FMC/AC/MC versions accept armor about 0.56–0.61 in (14–15.5 mm) OD; reduced-wall 3/8 in flex may enter a 1/2 in knockout.
- 3/4 in FMC is about 26–28 mm OD. Some clamp lines stop near 1 in; duplex fittings take two 3/8 in conduits/cables.
- Straight, 45° and 90° bodies are available.
Where it is used
Residential/commercial building wiring and rough-inMotor/equipment/appliance whipsLighting/fixture whipsJunction-box connections
Variations
- Straight squeeze connector (flex to knockout)
- 90-degree squeeze connector
- EMT set-screw to flex squeeze combination coupling
- Insulated-throat versions
- Zinc die-cast or steel bodies
- 45 degree
- single-screw and two-screw saddle
- duplex (two-cable)
How to recognise it
Round open sleeve whose lower half is a split strap ending in two ears joined by a single screw underneath; often marked with trade size and UL. A small viewing hole or stop ring sits where the conduit bottoms.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Screw-in (twist-in) FMC connector | Screw-in types thread into the conduit's helix internally with a spiral insert and have no external strap/screw ears. |
| AC/MC cable (BX) clamp connector | Cable connectors look similar but are listed for armored cable with an anti-short bushing seat; FMC fittings are marked for flexible metal conduit trade size. |
| Liquidtight (LFMC) connector | LFMC fittings use a threaded compression nut, ferrule and sealing ring, not a single screw strap. |
| EMT set-screw connector | EMT ends are a closed round sleeve with a set screw bearing directly on smooth tubing; no split saddle. The EMT version has a smooth rigid-tube socket and a single set-screw that bears straight down, not a saddle that wraps around. |
| NM cable clamp connector | NM clamps squeeze flat sheathed cable with a strap; they are not sized for round armor. |
Also called
FMC squeeze connector endflex squeeze clamp; squeeze-type flex fittingGreenfield squeeze connectorflex clamp endAC/MC/FMC squeeze connectortwo-screw flex connectorFMC clamp connectorGreenfield clamp connector
Good to know
Not threaded, not NPT. Fit depends on FMC trade size rather than a precise dimensional standard; the clamp accepts a small OD range. On the sample part this is the flex half of an EMT set-screw x flex combination coupling.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

