How it connects
The female receptacle's rolled spring contacts slide over the flat tab and grip it by spring force; many tabs have a dimple or hole that a locking receptacle latches into. Not sealed. The tab itself is crimped to a wire, soldered or PCB-mounted.
Male and female halves
Male = flat tab/blade (this connection); female = receptacle or 'push-on' that wraps around it.
Usually connects to
- Female FASTON/push-on quick-disconnect receptacle matched by blade width, thickness and retention shape, such as 6.3 × 0.8 mm (0.250 × 0.032 in)
- Matching piggyback terminal
Common sizes
- Common tab widths: 2.8 mm (0.110 in), 4.8 mm (0.187 in) and 6.3–6.35 mm (0.250 in); also 2.0, 5.2 and 9.5 mm. Thickness is commonly 0.5 or 0.8 mm (0.020 or 0.032 in).
- FASTON .250 commonly means 6.35 × 0.81 mm (0.250 × 0.032 in). A 4.75 mm alternative is also reported; confirm the switch dimensions and insertion length.
Where it is used
appliance wiringrocker and toggle switchesrelaysHVAC controlspower suppliesmarine and automotive 12 V wiringfuse blocksHVAC electrical components; Electrical machinery
Variations
- Non-insulated crimp tab
- PCB, screw/stud mount or molded-in device tab
- With/without locking dimple/hole
- Fully/partly insulated or bare
- Piggyback male/female adapter
- Thin 0.250 × 0.020 in tab
How to recognise it
A flat, rectangular metal blade (typically 6.3 mm wide, 0.8 mm thick) sticking out from a device or crimp barrel, often with a small round hole or dimple near its centre and a slightly chamfered tip.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| spade / fork terminal (ring-tongue type for screw terminals) | A fork spade has a U-shaped open end that goes under a screw head; a quick-disconnect tab is a solid flat blade that a receptacle slides over. A fork spade has an open U slot that goes under a screw head; a quick-connect tab is solid and takes a slide-on receptacle. A fork terminal has an open U-shaped slot for a screw; a male quick-disconnect has a solid projecting blade for a push-on receptacle. |
| blade fuse terminals / NEMA plug blades | NEMA plug blades are part of a mains plug body mating a wall outlet; quick-disconnect tabs are individual terminals mating loose receptacles. |
| ATO/ATC blade fuse terminals | Fuse blades are paired, narrower and plug into a fuse socket, not a single receptacle sleeve. |
| Other quick-disconnect tab sizes | Measure blade width and thickness; a visually similar .187 tab is narrower than a .250 tab. Insulation colour describes wire range, not mating dimensions. |
Also called
male spade terminal; flat plug terminal (Flachstecker)male tab terminal; male blade terminalFaston tabpush-on tab1/4 inch spade6.3 mm tab1/4 in quick-connect tabMale quick-disconnect tab
Good to know
Tab width and thickness must match the receptacle. Switches may use 6.3 × 0.8 mm, 4.8 mm or 2.8 mm tabs; check the specific switch.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

