How it connects
The cable sits inside the loop; tightening the screw through the tab(s) closes the loop around the cable and holds it to the surface. Rubber/EPDM lined versions cushion and grip; no sealing.
Male and female halves
No true male/female pair. The loop acts as the receiving (female) side for the cable or tube passing through it; the tab is the mounting side for a screw.
Usually connects to
- Round cable, cord bundle, hose or tube sized for the clamp opening
- Panel/frame/support surface through the tab’s screw, bolt or rivet
Common sizes
- Select by cable/bundle diameter, separately from mounting-hole size. Loop ranges include about 3 mm to over 50 mm (1/8–2 in and larger), with bands typically 10–20 mm wide.
- Small examples include 5 mm or 6.4 mm (1/4 in) ID and a 10 mm band; one supplier lists 3.2–25.4 mm versions.
- Bundle-capacity versions include 1 in (25.4 mm), 2 in and 3 in; PPR-1500 is nominal 3/8 in (9.525 mm).
- A reported 23 mm opening and 10 mm contact length are not established fit dimensions; check each model and mounting hardware.
Where it is used
Cable routing/support, bundle organization and cord storageAutomotive/marine wiringAerospace harnessesMachinery, panels and internal equipment wiringHydraulic/fuel-line routing
Variations
- Plain or rubber/EPDM-cushioned steel/stainless/zinc-plated P-clip
- Cushioned aluminum
- Single or double/twin clip
- Molded nylon R-clip, including PA66, black or natural/white
- Different bundle diameters and mounting-hole sizes
How to recognise it
A strip bent into a round loop with its end(s) flattened into a flat tab with a screw hole, profile shaped like a P; often black rubber lining inside the loop; nylon versions are one molded piece with a hole tab.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Hose clamp (worm-drive) | A hose clamp tightens a band around a hose onto a barb and has no mounting tab; a P-clip has a screw tab to fix the cable to a surface. |
| Electrical cable connector socket | Saddles strap over the cable with two screws on either side; a P-clip is one closed loop with the hole(s) on a single tab. The intended item is a reusable cuff with a release button; verify the mechanism rather than treating every cable restraint as this type. A cable clamp surrounds the cable jacket without electrical mating contacts. |
| Cable gland | A gland surrounds a cable at an enclosure entry and typically uses a threaded body and compression seal; this clamp is an external support loop with mounting tabs. |
| Electrical socket or terminal | The cushioned loop bears on the cable jacket; it has no electrical mating contacts. |
Also called
R-type cable clip; R-type cable clampcushioned loop clamp; cushioned P-clamprubber-lined P clipAdel clampCable Cuff PROReusable cable-bundle clamprubber-insulated cable clampnylon cable saddle
Good to know
Not a mating connection in the plug/thread sense: it is a cable retention clamp. Suggest a generic 'cable clamp loop' type parameterised by loop ID that receives a round cable/tube.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.




