How it connects
Two cast curved or angular jaws with serrated ridges wrap around the pipe OD and are clamped tight by tightening two threaded clamping bolts, biting through surface oxide or paint to create low-resistance electrical bonding.
Male and female halves
Female clamping saddle/collar that encircles and compresses onto the male pipe OD exterior surface.
Usually connects to
- Copper-bonded/copper-clad or galvanized ground rod, including 1/2, 5/8 and 3/4 in examples
- Rebar for a concrete-encased/Ufer electrode
- Copper, iron or steel IPS/NPS water pipe
- RMC or IMC
- Bare or armored copper grounding-electrode conductor
Common sizes
- Rod sizes: 3/8, 1/2, 5/8 and 3/4 in, with single-size and range-taking clamps. NSi GRC-3834 accepts 3/8–3/4 in rod and 3/8–5/8 in rebar; other markings include #4–#5 rebar.
- Pipe clamps span roughly 1/2–6 in IPS in ranges such as 1/2–1, 1-1/4–2, 2-1/2–4 and 4-1/2–6 in.
- Conductor ranges commonly start at #10 AWG and reach #2 or 1/0 stranded; heavy-duty versions can accept 3/0 or 4/0 AWG.
Where it is used
electrical grounding and bonding; electrical service groundingservice entrance installationswater meter bonding jumperslightning protection systemstelecom/utility groundingbuilding grounding electrode systemsdirect burial earth bondingconcrete-encased electrode bonding (Ufer grounds)
Variations
- Water-pipe clamp with wire-binding screw
- Direct-burial bronze/stainless-hardware clamp
- Integral conduit hub
- Heavy-duty U-bolt pipe/rod clamp
- Single-bolt acorn, including rebar-listed versions
- Lay-in, range-taking or breakaway-head variant
How to recognise it
Recognised by two cast bronze or brass clamp halves with grooved or stepped serrated gripping teeth across the inner arc, secured by two long perimeter machine screws/bolts and featuring a wire lug or terminal screw.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Plumbing pipe repair clamp / split sleeve | Plumbing repair clamps feature a continuous rubber/elastomeric gasket intended for fluid sealing rather than serrated bronze jaws for electrical continuity. |
| Kee Klamp / structural slip-on pipe fitting | Structural fittings use a cylindrical slip-on sleeve secured by set screws for mechanical framing rather than bolted two-piece serrated jaws designed for electrical grounding. |
| Water pipe ground clamp (strap or two-piece pipe clamp) | Pipe clamps wrap around larger pipe OD with a strap or split body and two screws; acorn clamps are a closed one-piece loop with a single screw sized for a solid rod. |
| Exothermic weld connection | Welded joints are fused with no screw or removable body. |
| U-bolt / GP-type ground rod clamp | That type uses a U-bolt with two nuts and a saddle. The acorn clamp is a solid one-piece cast loop with a single screw. |
Also called
pipe grounding clampwater pipe ground clamp; electrical ground clamp for pipeserrated jaw ground clampGRCacorn ground clamp; acorn clamp openingrange-taking ground rod clamp; ground rod clamp openingrebar ground clampdirect burial clamp eye
Good to know
The name specifically refers to the pipe-gripping saddle interface of an electrical grounding clamp, which uses serrated teeth to establish metal-to-metal electrical contact with the pipe OD.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


