How it connects
Inserted into a drilled hole in solid concrete; tightening the nut pulls the tapered lower end upward, forcing the expansion clip outward against the concrete wall via friction and mechanical wedging.
Male and female halves
Male stud / anchor body that mates into a female cylindrical drilled hole in concrete (with external male machine threads at the exposed end mating with a female hex nut).
Usually connects to
- Matching drilled hole in solid concrete or approved grout-filled CMU/masonry
- Matching UNC or metric hex nut and washer
Common sizes
- Nominal bolt diameters 1/4–1-1/4 in (about 6–32 mm); metric lines are listed as M6–M24 or M6–M30.
- Overall lengths typically 1-3/4–12 in or longer.
Where it is used
Structural steel and industrial framingConcrete construction, including cracked/seismic anchorsHeavy machinery and pallet racksMEP/pipe/duct supportsFacades
Variations
- Cracked-concrete/seismic-rated, including KB-TZ2/Strong-Bolt 2/Power-Stud+ SD1
- Dual/two-clip wedge
- Tie-wire type
- 304/316 stainless
- Hot-dip/mechanically galvanized or zinc-plated carbon steel
How to recognise it
Recognized by a solid threaded steel stud having a tapered cone profile at its embedment tip, encircled by a small split expansion ring/clip with protruding gripping dimples or tabs.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| concrete sleeve anchor | Sleeve anchors have an external split sleeve running nearly the full length of the bolt rather than just a small collar clip near the tapered end. Sleeve anchors have an external split sleeve running the full length of the bolt rather than a short expansion clip positioned over an integral tapered mandrel at the bottom tip. |
| concrete drop-in anchor | Drop-in anchors are female internally threaded flush cylinders expanded with an internal setting plug and punch, whereas wedge anchors are male threaded studs. Drop-in anchors are internally threaded female inserts expanded using an internal plug driven by a setting tool, whereas wedge anchors are male studs with external clips expanded by torquing a nut. |
| concrete screw anchor (e.g. Titen HD / Tapcon) | Concrete screws have external helical threads that cut grooves into the concrete hole wall rather than relying on an expansion clip and wedge taper. Concrete screws cut matching female threads directly into concrete along their entire shaft without any expanding clip or tapered mandrel. |
Also called
concrete wedge anchorconcrete expansion boltthrough-bolt anchorexpansion clip anchorwedge anchor studexpansion stud endwedge bolt expansion tiptorque-controlled expansion anchor stud
Good to know
Intended specifically for solid uncracked/cracked concrete; not suitable for hollow brick or soft masonry. The connection interface comprises both the mechanical expansion anchor clip in concrete and the exposed machine thread. Additional standard references: ASTM A193 (/A193M).
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.



