How it connects
Driven by hammer into a pre-drilled hole equal to anchor shank diameter; the pre-expanded split halves compress upon insertion, exerting outward spring friction against the hole wall.
Male and female halves
Male split shank driving into a female cylindrical drilled masonry hole.
Usually connects to
- Drilled cylindrical hole in solid concrete, grout-filled block, hollow block, or brick
- drilled hole in solid masonry
- Concrete masonry unit (CMU) hole
- drilled solid wall hole (concrete, solid brick, stone, or block)
Common sizes
- Outer anchor diameters commonly 1/4–3/4 in (about 6–20 mm; M6–M20), with the hole matching nominal anchor diameter.
- Lengths span roughly 5/8–6-1/4 in (about 15–160 mm); many 1/4 in anchors are 1-1/2–3-1/2 in, with versions up to 5 in.
Where it is used
concrete construction; commercial constructiondrywall trackswood-to-concrete furring stripstamper-resistant light-to-medium duty anchoringresidential masonry fasteningstructural steel baseplates; structural fasteningframing anchoringelectrical and plumbing bracket mounting
Variations
- Countersunk flat slotted/Phillips head
- Round/mushroom head
- Hex or acorn nut
- Tie-wire head
- Zinc-plated carbon steel or 304/316 stainless
How to recognise it
Recognised by a solid unthreaded steel shank terminating in two bowed or sheared outward-bulging split halves near the base, with either a flat countersunk or round mushroom head.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| Hammer drive pin anchor / strike anchor | Hammer drive pin anchors have a tubular expansion sleeve and an internal drive pin; split drive anchors are solid one-piece steel with a bowed split end and no pin. |
| Concrete wedge anchor | Wedge anchors feature threaded studs, nuts, and a separate expansion clip; split drive anchors are unthreaded single-piece drive pins. Wedge anchors feature a solid threaded stud with only a small clip/collar near the bottom cone, whereas sleeve anchors have a tubular sheet metal sleeve covering almost the full length of the bolt body. |
| Concrete drop-in anchor | Drop-in anchors are female internally threaded cylinders expanded by a setting tool, whereas sleeve anchors are pre-assembled through-bolt male fasteners with an external nut/head. Drop-in anchors are female internally threaded shells set with an internal plug and setting tool before a separate bolt is inserted; sleeve anchors are preassembled male fasteners with an integral expander and outer sleeve. |
| Expansion shield anchor | Expansion shields are separate alloy split casings inserted first, then driven by inserting a standard lag screw or machine bolt. |
Also called
split drive anchorpre-expanded split anchortamper-proof drive anchorConcrete sleeve anchor; Expansion sleeve anchorLok-BoltDynaboltSleeve-Allmasonry sleeve anchor; sleeve bolt anchor
Good to know
Permanent and tamper-resistant fastener; once driven into concrete, it cannot be unscrewed or removed without cutting the head or breaking the concrete. Additional standard references: Federal Specification FF-S-325 Group II Type 3; Federal Specification FF-S-325C Group II Type 3 Class 3.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


