How it connects
Screwed into a matching #6-32 internal thread (tapped hole, nut or threaded insert); held by thread engagement and head bearing clamp load. Not a sealing thread (60° straight, non-tapered).
Male and female halves
Male / external thread (screw, class 2A typical); mates with female / internal #6-32 thread (tapped hole or nut, class 2B). This connection is the male half.
Usually connects to
- Matching #6-32 UNC tapped hole in a device yoke/strap, box mounting ear, mud/plaster ring or extender, in metal or plastic
- #6-32 hex nut
Common sizes
- #6-32 UNC: 0.138 in major diameter, 32 TPI, 0.794 mm pitch, 60° form; #6-40 UNF is a separate fine-series size.
- Lengths span about 1/8–3 in. Wallplate screws commonly 3/8–1 in; device screws commonly 1/2–1 in, often 5/8 in or longer; extensions are commonly 1-1/2–3 in.
Where it is used
Residential/commercial electrical wiring and device-box installationSwitch/outlet wallplatesElectronics enclosures/instrumentationMachinery, hobby/robotics and general fastening
Variations
- pan, flat (82° countersunk), oval, round, socket-head cap screws
- UNC-2A/3A tolerance classes
- #6-40 UNF (fine series, not interchangeable)
- oval head slotted wall plate screw
- captive (retained) yoke screws on devices
- oval/truss/flat head, slotted or combo Phillips-slot
- extra-long screws for recessed boxes
- wall plate screws (same thread)
How to recognise it
Small blunt-ended screw about 3.5 mm in diameter with 32 threads per inch (~0.79 mm pitch), uniform 60° straight thread along the shank; on duplex receptacles and switches it appears as the captive slotted/Phillips screws at each end of the mounting strap.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| #8-32 UNC | Same 32 TPI pitch but larger diameter (0.164 in vs 0.138 in); #8-32 is used on wallplate screws for some devices and box-to-device in some cases—measure diameter. |
| M3.5x0.6 metric | Very close in size (3.5 mm vs 3.51 mm) but pitch 0.6 mm vs 0.794 mm (32 TPI); check with a pitch gauge. |
| #6 wood/sheet-metal screw | Tapping screws have a pointed tip and wider-spaced, sharper threads; machine screws have a blunt end and uniform fine threads. |
| #6-40 UNF | 40 TPI finer pitch vs 32 TPI |
| M3.5 x 0.6 metric | Similar diameter but 0.6 mm pitch vs 0.794 mm; won't fully engage |
Also called
No. 6-32 UNC-2A6-32 machine screw#6-32 coarse threadwall plate screwelectrical box screwoutlet/switch mounting screwyoke screw6-32 device mounting screw
Good to know
On a NEMA 5-15R duplex receptacle, strap-to-box screws conventionally use #6-32. The wallplate screw is also typically #6-32.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


