How it connects
Parallel (straight) 60° V-thread screwed together by turning counter-clockwise to tighten; no sealing, purely mechanical. In turnbuckles paired with a right-hand end so rotating the body draws both ends in.
Male and female halves
Female/internal thread (nut, tapped hole, class 2B); mates with a male/external 3/8-16 UNC LH thread (class 2A). This port is the female.
Usually connects to
- Male 3/8-16 UNC LH threaded rod/bolt/stud (e.g. turnbuckle hook, eye or jaw end)
Common sizes
- This item is the single size 3/8-16 (9.525 mm major dia, 1.5875 mm pitch). LH UNC exists across the UNC series, roughly #4-40 to 1-1/2-6 and larger.
Where it is used
turnbuckles and rigging hardwaremachinery (left-side rotating parts, e.g. grinder/saw arbors)tie rodsgeneral fastening
Variations
- 3/8-16 UNC RH (standard)
- class 1B/2B/3B fits
- 3/8-24 UNF LH (fine pitch)
How to recognise it
Tapped 3/8 in bore with 16 TPI; thread lead runs the opposite way to normal (helix rises to the left). On turnbuckles one end of the body is RH, the other LH; the LH end/fitting is sometimes marked with a notch, groove or 'LH'.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| 3/8-16 UNC right-hand | Same size and pitch; LH thread helix slopes up to the left when held vertically, and the male part tightens counter-clockwise. Often marked LH or with a groove/notch. |
| M10x1.5 metric | Close in size (10 mm vs 9.525 mm, 1.5 vs 1.5875 mm pitch) but not interchangeable; check with a thread gauge. |
| 3/8 NPT | NPT is tapered, 18 TPI and much larger (about 0.675 in OD). |
Also called
3/8-16 UNC-2B LH3/8"-16 LH internal thread3/8 x 16 left-hand tapped thread
Good to know
UNC means Unified coarse thread. Check the left-hand and right-hand ends of a turnbuckle individually.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.


