How it connects
Secured mechanically by threading a female lock nut (often with jacking screws and a friction washer) onto the shank against the underside of the mounting deck; it does not carry fluid or seal water.
Male and female halves
Male external thread on the faucet shank mating with a female internal thread on the underside mounting lock nut.
Usually connects to
- Faucet deck mounting nut (1 1/4-18 UNEF female)
- faucet mounting lock nut with jacking screws
Common sizes
- 1 1/4 in nominal diameter with 18 threads per inch (major diameter ~31.75 mm / 1.25 in).
Where it is used
residential plumbingcommercial plumbingkitchen and bathroom faucet installation
Variations
- 1/2-14 NPSM faucet shank
- M32 metric faucet shank
- M33 metric faucet shank
- 1 1/8-18 UNEF faucet shank
How to recognise it
Hollow brass or stainless steel cylindrical post extending from the bottom of a single-hole faucet body, featuring fine external machine threads (18 TPI) measuring roughly 1.25 in (31.8 mm) OD, designed to accommodate internal water supply lines and pull-down spray hoses.
Often confused with
| Confused with | How to tell them apart |
|---|---|
| 1/2-14 NPSM Faucet Shank | 1/2-14 NPSM has a significantly smaller outer diameter (~21 mm / 0.825 in) and 14 TPI, common on two-handle centerset faucets rather than single-hole kitchen/utility faucets. |
| 1 1/4-inch Tubular P-trap Slip Joint | Tubular slip joints use unthreaded or threaded brass/poly tubing with slip washers for drainage, rather than structural UNEF mechanical mounting shanks. |
Also called
1 1/4-18 UNEF faucet shankfaucet mounting shank threaddeck mounting nipple
Good to know
This thread is strictly a mechanical mounting fastener to clamp the faucet against the deck, not a fluid conduit.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.

