How it connects
Screwed clockwise into a pilot hole of tap-drill size; the chamfered lead and flutes cut a 60° Unified internal thread. No seal; the result later mates with UNC male fasteners.
Male and female halves
This is the male (external) thread form; it produces the female (internal) UNC thread that mates with UNC bolts/screws of the same size and pitch.
Usually connects to
- drilled tap-drill-size hole (cuts a female UNC thread, class 2B typical)
- tap wrench or T-handle via square drive
Common sizes
- Numbered machine-screw sizes #1-64 to #12-24 and fractional 1/4-20 up to about 1-1/2-6 UNC and beyond; e.g. #8-32 = 0.164 in major diameter, 32 TPI.
Where it is used
machiningmetalworkingfastener hole threadingrepair
Variations
- taper, plug and bottoming chamfer
- spiral-point and spiral-flute taps
- left-hand taps
- UNF fine-pitch taps
- thread-forming (roll) taps, which do not cut
How to recognise it
Straight shank with a square drive end, a threaded section broken by 2-4 straight or spiral flutes, and a chamfered tip; shank usually marked with size and pitch (e.g. 8-32 NC, GH3, HSS).
Often confused with
| Confused with | How to tell them apart |
|---|---|
| NPT pipe tap | NPT taps are tapered along the thread length and have a 1:16 taper; UNC taps are straight (only the lead chamfer tapers). |
| Metric (M) tap | Marking reads M size x pitch (e.g. M4x0.7); UNC taps are marked size-TPI like 8-32 NC/UNC. |
| UNF tap | Same diameter but more threads per inch (e.g. #8-36 UNF vs #8-32 UNC). |
Also called
hand tapplug tapmachine screw tapUNC tapcut tap
Good to know
This is a cutting tool’s working end, with the specified male UNC Unified inch thread geometry. It is distinct from tapered NPT.
Related connections
Design with real parts
Crafti checks which parts connect, right in your browser.



